Warning: The sample courses in this manual are already examined for accuracy, but They are really for illustrative uses only. The systems tend not to determine tools, offsets, or elements.
Danger: At this time, there really should be no electrical connection on the device. Electrical panel should be shut and secured. When most important swap is on, There exists Large VOLTAGE all over the electrical panel (including the circuit boards and logic circuits) and several components operate at high temperatures. Hence, exercising Severe warning when Doing the job within the panel.
Introducing the enhanced ST-20/twenty five CNC Lathes, featuring a better chopping experience with its Improved Z-axis vacation and economical chip evacuation. In addition, these lathes boast a compact structure that has a diminished footprint.
Confirm which the machine is degree by moving the turret alongside the Z-axis and examining for twist and continue adjusting until degree.
Observe: Trunnion models current interference concerns with the swing in the device relative towards the equipment column and spindle head.
Observe: Be certain that the qualified prospects truly go in the terminal-block clamps . (A very poor connection will lead to the machine to operate intermittently or have other troubles, which include servo overloads.) To examine, simply just pull within the wires once the screws are tightened.
With all the equipment in operate mode, shut the device doorway, run the spindle at a hundred RPM, pull the door and validate the door would not open up.
Solitary-Head Rotary Single-Head Rotary Tables and Indexers are usually mounted to the appropriate side on the desk, While using the rotary dealing with the centre on the device. This is actually the fundamental set up we employed to find out the fit of one's rotary product.
In case the environmentally friendly neon is lit (NE6), the phasing is correct. If the two neon indicators are lit, you have a loose wire; Examine the connections. Modify phasing by setting the resource electricity to off and then swapping L1 get more info and L2 of your incoming electric power lines at the principle circuit breaker.
When unlocked, setup method enables a talented machinist far more entry to the equipment to create Positions. Within this mode, equipment conduct is depending on whether the doorways are opened or shut. The subsequent charts summarize the modes and allowed capabilities.
Keep your palms and entire body away from the realm among the tailstock and workholding when computerized movement is achievable.
Move the turret again towards the spindle as considerably as possible and raise or lessen screw one to Centre the bubble.
Only insert a suggested tooling package to the equipment estimate or search our wide selection of Haas Tooling products under:
Warning: Only licensed and experienced personnel could run this devices. You should normally act in accordance Together with the Operator's manual, protection decals, security treatments, and instructions for Safe and sound device operation. Untrained personnel current a hazard to by themselves along with the device